MyVans Your Vehicle Solution
Have you noticed that your car’s splash guard is hanging loose or dragging on the ground? This can be a frustrating problem, especially if you drive on rough roads. However, fixing a splash guard is not as complicated as it may seem. In this article, we will guide you through the steps of fixing a splash guard under your car.
What is a Splash Guard?
A splash guard is a plastic or rubber shield mounted under the front bumper of a car. Its purpose is to protect the engine compartment and other components from water, mud, and debris that can be thrown up from the road. A splash guard also helps to improve aerodynamics and reduce wind drag.
Step-by-Step Guide to Fixing a Splash Guard
Step 1: Locate the splash guard. The splash guard is usually attached to the bottom of the front bumper with clips or screws. You can find it by looking underneath the car.
Step 2: Remove the damaged or loose splash guard. If the splash guard is damaged or torn, you may need to remove it completely. If it is just loose, you can try to reattach it using clips or screws.
Step 3: Clean the area around the splash guard. Use a rag or a brush to remove any dirt, debris, or rust around the mounting area. This will help the new splash guard to attach more securely.
Step 4: Install the new splash guard. If you need to replace the old splash guard, you can buy a new one from an auto parts store or online. Follow the manufacturer’s instructions to install the new splash guard. Make sure it is aligned properly and securely attached to the bumper.
Step 5: Test the splash guard. Once you have installed the new splash guard, take your car for a test drive on a bumpy road. This will help you to make sure that the splash guard is securely attached and does not drag on the ground. If you notice any noises or vibrations, stop and check the splash guard again.
Tips for Maintaining Your Splash Guard
Here are some tips to help you maintain your splash guard and prevent it from becoming loose or damaged:
- Regularly inspect the splash guard for signs of damage or wear and tear.
- Clean the splash guard regularly to remove dirt and debris.
- Take your car to a car wash instead of washing it at home with a pressure washer, which can damage the splash guard.
- Be careful when driving over speed bumps or potholes, which can cause the splash guard to scrape on the ground.
Conclusion
Fixing a splash guard under your car is a simple task that can be completed in a few steps. By following the instructions outlined in this article, you can save money on expensive repairs and ensure that your car is protected from water, mud, and debris while driving. Remember to maintain your splash guard regularly to prevent it from becoming loose or damaged.
