How to Reset Ford F150 Keyless Entry Without Factory Code

1 Views

Keyless entry is a great convenience for car owners, but it can become a headache when the system fails. If you have a Ford F150 and the keyless entry is not working, you may find yourself locked out of your vehicle. Fortunately, there are ways to reset the keyless entry without the factory code. In this article, we will show you how to reset the keyless entry on your Ford F150.

Fast Read : show

Method 1: Using the Master Reset

The master reset is the easiest way to reset the keyless entry on your Ford F150. This method requires no tools or special equipment, and it can be done in a matter of minutes.

Step 1: Enter the Vehicle

The first step is to enter the vehicle and close all doors. Make sure the key is not in the ignition and all other accessories are turned off.

Step 2: Press the Unlock Button

Next, press and hold the unlock button on the keyless entry remote for at least four seconds. While holding the button, turn the key to the “On” position and then back to the “Off” position. Repeat this step two more times.

Step 3: Release the Unlock Button

After the third cycle, release the unlock button on the remote. The doors should automatically lock and unlock, indicating that the master reset was successful.

Method 2: Using a Keypad Code

If your Ford F150 is equipped with a keypad, you can use a code to reset the keyless entry. This method requires you to know the factory code or have access to the owner’s manual.

Step 1: Enter the Factory Code

The first step is to enter the factory code on the keypad. If you don’t know the code, check the owner’s manual or contact your Ford dealer.

Step 2: Press the 1/2 Button

After entering the factory code, press the 1/2 button on the keypad within five seconds. The doors should automatically lock and unlock, indicating that the system is in programming mode.

Step 3: Enter a New Code

Next, enter a new code on the keypad. The code must be between three and eight digits long. After entering the code, press the 1/2 button again to store the new code. The doors should automatically lock and unlock, indicating that the new code has been programmed.

What If I Don’t Have the Factory Code?

If you don’t have the factory code, you can still reset the keyless entry by following these steps:

Step 1: Locate the Smart Junction Box

The Smart Junction Box (SJB) is located under the dash on the driver’s side of the vehicle. Remove the cover to access the SJB.

Step 2: Disconnect the Battery

Disconnect the negative battery cable and wait at least five minutes before reconnecting it. This will reset the SJB and the keyless entry system.

Step 3: Test the Keyless Entry

After reconnecting the battery, test the keyless entry to make sure it’s working properly. If it’s still not working, you may need to take your Ford F150 to a certified technician for further diagnosis.

MyVans Your Vehicle Solution